The TSW Submersible Sump Pump is an innovative alternative to the traditional submersible sump pumps. This pump features a solid state "IntelliSwitch" automatic switch and alarm circuit that eliminates the potential hang ups seen with float switches. The alarm portion of the circuitry is built into the "IntelliPlug" power cord plug. It has an audible alarm and a red warning light to indicate a high water condition in the sump. The "IntelliPlug" also has a green run light to show the pump is operating.
Features:
- Includes pump, 22" basin, clear view cover assembly and discharge kit with clear check valve
- Pump is UL and CSA certified
- Center discharge (1-1/2" NPT) for suspended installation from
sump basin cover, to keep pump off the bottom where gravel or
other debris are more likely to cause clogging that may result
in a flooded basement
- Integral IntelliSwitch® with no moving parts for the most reliable
automatic turn-on and turn-off operation, a high water alarm
activation that reduces the potential for mechanical switch
malfunction or failure that may result in a flooded basement
- Integral IntelliPlug® that provides a red, high water alarm light
and 85 db buzzer, a “push-to silence” switch and a green run
light to show when pump is running
- Bottom screened inlet and a recessed, vortex impeller to reduce
the potential for clogging that may result in a flooded basement
- Both upper and lower ball bearings for smooth, quiet operation
and longer motor life
- Mechanical shaft seal provides protection against water entry
into the motor
- All exposed component parts of the pump are made of corrosion - resistant materials to provide a longer service life
- Environmental friendliness in mind: Powerful and efficient 1/3 HP permanent split capacitor
motor draws less than 5.0 full load amps, conserving energy while delivering 40 GPM at 10' total dynamic head
Specifications:
- PSI: 14.3
- HP: 2
- Hz: 60
- Volts: 115
- GPM at 5' of Head: 45
- Discharge Port: 1.5"
TSW Series Spec Sheet
