The Powermax30 plasma cutting system is the ultimate system for metal cutting up to 3/8." It’s designed and built for tough environments but is very compact and weighs only 20 pounds.
Boost Inverter technology creates a full 30-amp rated plasma cutter with the most cutting power of any machine operating on household (120V) input power.
Features:
30 amps, 2.5 kW output
Auto-voltage circuit
Boosted open circuit voltage
Active electronic pilot arc controller
Consumable holder
Factory pre-set air regulator
No contactors, fuses or mechanical relays
Comfort-molded carry handle
Fold-out cable wrap hooks
Attachable "bandolier" for consumable storage
Auto-Voltage
Simple Panel Design with minimum controls
Factory set air regulator
Torch hard-wired to system
IP23CS compliance for resistance to rain damage
Hand torch cut capacity:
Recommended: up to 1/4" (6 mm) at cutting speeds of 33" (838 mm) per minute
Maximum: up to 3/8" (10 mm) at cutting speeds of 15" (381 mm) per minute
Severance: up to 1/2" (12 mm) at slow speed
Includes:
Powermax 30« Power Supply
T30v Torch & 15' Lead Assembly
Spare Consumables
15' Work Cable With Clamp
Applications:
Steel construction
Automotive repair and fabrication
HVAC fabrication and installation
Plumbing and sprinkler installation
Commercial kitchen installation
Heavy equipment maintenance
Farm work
Earth-moving
Mining
Metal artwork
Specifications:
Input voltages:
120–230 V, 1PH, 50/60Hz
Input current @ 2.49 kW:
120–230 V, 1PH: 26–13.5 A
Output voltage:
83 V
Duty cycle @ 104°F (40°C) @ 30 A:
35% @ 30 A, 115 V
50% @ 30 A, 230 V
Output for 100% duty cycle @ 104°F (40°C):
18 A @ 120 V
21 A @ 230 V
Maximum OCV:
240 V
Gas supply:
Clean, dry, oil-free air or nitrogen
Flow rate minimum:
3.5 scfm @ 65 psi (99.1 l/min @ 4.4 bar)
Flow rate recommended:
4.0 scfm @ 80–140 psi (113.3 l/mm @ 5.5 bar)
Dimensions:
12" H x 6.6" W x 14" D
Weight:
20 lbs (with torch)
Backed by Hypertherm's full three-year power supply warranty and one-year torch warranty. No parts excluded.
Powermax30
